Post-installation


Enable services

After completed installation, perform several steps to put the appliance in service:

  • Go to the landing page of the appliance by typing the appliance hostname/IP address in a browser. Via a menu of the page, you can get access to Alertflex web console or open admin consoles for components of the solution.
../_images/main-page.png ../_images/main-menu.png
  • Open Alertflex console, read and confirm EULA, enable Worker (default user admin, password was set in env.sh file).
../_images/project.png
  • Open Payara admin console, change password for user admin (default password admin).
../_images/payara-user.png
  • Open MISP admin console, change password for user admin@admin.test (default password admin). Enable feeds, fetch and store feeds data.
../_images/misp-feeds.png
  • Reboot of the appliance via SSH and check via Alertflex console that alerts from Wazuh are present at the dashboard.
../_images/dashboard1.png

Troubleshooting

  • Open ActiveMQ console (default user admin, password was set in env.sh file). Check messages in Queues panel, the amount of Messages Enqueued should be equal to the amount Messages Dequeued.
../_images/activemq.png
  • Check logs for Docker containers
sudo docker logs cnode
  • Reload Alertflex applications if required
../_images/payara-reload.png